Biogas blower repair plan implementation, the editor tell you about. The implementation of the biogas blower program will reduce the chance of production and replace the 2 system 3 wind turbines. The wind turbine has been corrected and operated for 12 months, and the air volume has dropped significantly. Pre-preparation work (1) Manufacture a special measuring tool (sham-rotor) for detecting the coating scale of the casing, support it on the bearing seat with the bearing, and install it in the front and rear wall panel tile nest to detect the wear condition of the casing. In order to determine the spray scale. (2)Manufacture of four false bearings, the dimensions of which are processed according to the bearing inner diameter, and the inner diameter and the diameter of the rotor shaft cooperate with each other for the cooperation of voids, and the void volume is 0.03-0.06 mm. Install the rotor on the casing and spray it. (3) The use of a waste piston rod or a fine round bar for measurement of wall plate spraying planes. (4) Blower breakdown, detection of rotor and upper case clearance A, rotor and lower case clearance A, rotor and rotor clearance B, rotor and wall plate positioning end clearance C, rotor and wall plate non-locating end clearance C, rotor length L and diameter D. After measurement, the wear of the blower is evaluated, and the backlash E of the gear pair is detected together. (The layout of the blower. This kit is a good solution to the fact that the centerline of the shaft is inclined relative to the centerline of the bearing seat hole during the heat generation of the previous graphite seal operation. The ability of the bearing to still work.

    Double-row radial spherical ball bearings and double-row radial spherical roller bearings have good aligning performance. Roller bearings and needle roller bearings do not allow relative tilting of the inner and outer ring axes. Different types of rolling bearings allow different tilt angles, such as single row radial ball bearings are 8′～16′, double row radial spherical ball bearings are 2°～3°, tapered roller bearings are less than or equal to 2′. The occurrence of a high-temperature safety accident is avoided. Durable and extremely stable, the mechanical packing seal has the lowest adaptability to the environment and fluid transport requirements compared to magnetic fluid seals. It is easy to overhaul and guarantee the soft oil impregnation state. It is easy to maintain.